Lid Stack Low Sensor Bracket spec_sheet The CP Seal Height Rod

The CP Seal Height Rod (AKA Tapped Linear Motion Shaft) is used on all Fusion Counter Pressure systems and is used to guide the Fill Head Raise Plate as it moves up and down

and polished to tight diameter and straightness tolerances

204 body: 57 cans

5" tri-clamp and gasket

Lid Stack Low Sensor Bracket spec_sheet The CP Seal Height RodThe Lid Stack Low Sensor Bracket is made of hard anodized aluminum and mounts to the Lid Dropper's Top Plate on current Evolution Series, Fusion Counterpressure and WG8 10 systems. This bracket holds the Lid Stack Low sensor in place. The Lid Stack Low sensor detects the presence of lids in the stack and notifies the operator when the stack is low. Software Requirements: Evolution Series v4. 0 or later Fusion Series v1. 09 or later WG8 10 (600) v1. 0